Extension Indicator

[cwhoop]

I have a nortel 3x8 dr5.1 and have 3 T7316Es and 3 7208s and a cordless. On the T7316e it should show when the extensions are in use. I have programmed with F*2 each extension to a button but only some of the extensions are in use. What can fix this???

 

[curlycord]

Not sure if all buttons are support for that on 3X8...which buttons are you using?

 

[cwhoop]

i was using 6 of the eight on the right side

 

[curlycord]

Will the top 5 on each side work?? 3 or 3 below your lines and the top 5 on the right.

I have never installed a T series on a 3X8 but I know it used to simulate an M7310 and those sets did not allow set appearance.

 

[cwhoop]

I think you are right... thank you so much

 

[curlycord]

Check out senks1 post half way down
senk1s

http://www.tek-tips.com/viewthread.cfm?qid=1369591

 

[cwhoop]

YOU WERE RIGHT... ONLY THE TOP THREE ON EACH WORK AS EXTENSION INDICATORS. I CHANGED THE AUTODIALS AROUND AND NOW IT WORKS GREAT... THANKS AGAIN