expantion cable and power suply ???

[abacomputers]

hello
i was wouldering if any one has the pin out for makeing an expantion cable . all my serches turn up nothing . is it just a standed cat5 cable ? it is to connect a atm16 and a ds16 to my 403.

also is there a power pack that would handle them all or do i have to use a stand alone power pack for each unit (403, atm16,and the ds16)??

 

[tlpeter]

Question 1, do not even go there.
It will nto work properly.

Question 2 see answer question 1.

Why do you want to do these things?


When you pay peanuts, you get monkeys!

I'm not insane, my mother had me tested!

 

[IPGuru]

1 ) yes I have the pinouts but they wont do you much good
see responce fro TLpeter.
interconnect cable must be 1M shielded!
sometimes prople think things are ok with longer cables but we have all seen the problems that happen with longer cables - even as shote as 2M on loaded systems.


I do not Have A.D.D. im just easily, Hey look a Squirrel!

 

[amriddle01]

The pinout is at the end of older (and maybe newer) installation manuals, go ahead and try it but it will end in tears

ACSS (SME)
APSS (SME)

http://www.ipoffice.tel

"I'm just off to Hartlepool to buy some exploding trousers