Mountainbear
Programmer
Trying to add a line to the BCM expansion mod 4x16. I have activated a the module and added sets. When I pug in a line to the front and program it on a set I get not in service.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Expansion Mod Lines 1
- Thread starter Mountainbear
- Start date
- Status
-
1
- #2
allworxguy
Vendor
Make the module is enabled in resources.
Be sure you are programing the correct line. Check in active physical lines for the correct Line number.
Marv ccna
Be sure you are programing the correct line. Check in active physical lines for the correct Line number.
Marv ccna
- Thread starter
- #3
Mountainbear
Programmer
I have programed line 065. It is listed in the inactive lines can't figure out how to move it to active lines. The module is active since I already have sets on it. It is the only expansion but could it be line 95? Will check resources again.
- Thread starter
- #4
Mountainbear
Programmer
Found it! Lines and sets are listed separate in the expansion. I had activated 1.1 but not 1.2
Thanks Allworxguy.
Thanks Allworxguy.
- Status
Similar threads
- Locked
- Question