Existing BCM50 to a BCM450 2

[Norcomm262]

Could anyone point me in the right direction please? I need to hook up a BCM450 to an existing BCM50 at another location. The customer would like three digit dialing between the offices and be able to transfer calls between the two.What specifically do i need to get this ball rolling from either the carrier side and the hardware side of things too.Thanks so much in advance.

 

[Dasheen]

U should go w/ a minimum of 4 digits for the DNs or you'll run out of number combinations etc.

U need MCDN key code, SIP/H323 VoIP trunks keycode, ...

 

[Jeffnortel]

Well a couple of different ways to approach this...

If you have a WAN connection between the two sites for data, then you could use IP trunks. This would require IS dept providing some sort of QOS across the WAN.

The easier way out is have telco provide a point to point T1 between the sites and puchase DTM cards for each site.

Both ways are good, one is a little more cost effective.(VoIP)

I would probable have a company engineer this for you b\c alot of things will need to be taken into consideration.