Executone w/ InfoStar VX2

[StinkTech]

I have the programming and admin manuals but no technical manuals. I'm trying to connect a InfoStar VX2 4 Port (2 RJ11, 2ports per jack) Voice Mail system to a 228 IDS Executone. The Executone is a 4 wire system. Does anyone have the pinouts to connect the two VX2 RJ11 Jacks (4 Ports) to the Executone?

Thanks in Advanace
StinkTech

 

[metballnut]

Ah, the Infostar....
Look, the infostar is a SLT configuration.
Although the Executone is a four wire system, you need a single line card in the switch and one pair of wires per slt port. You cannot convert the infostar to a digital station 9well, you could but the cost and hassle would suck)
Find a SLT Card and wire the 25 pair cable out accordingly.
Use your buttset, ID 4 slt ports (ports 1,2,3,4).
Take the rj11 (out of the Infostar) and punch it down on a 66 block and then cross connect it to the slt ports on the Executone slt.
You will need to set up the Executone equivalent of a hunt group for one touch access to the Infostar.
Hope this helps.