Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Executing remote commands between iseries

Status
Not open for further replies.
George221

George221

MIS
Dec 2, 2005
50
US
I'm looking into a way to run jobs on another iseries and came accross the RUNRMTCMD. I was hoping the RMTUSR *CURRENT would pass my credentials and authenticate me on the target system if my passwords were in sync but it doesn't seem to work. Is there a better way to do this?
Thanks.
 
Status
Not open for further replies.

Similar threads

chipperjonesrules
  • Locked
  • Question
csv files and macros when sent from as400 iseries
Replies
1
Views
102
itsp1965
itsp1965
wowhead
  • Locked
  • Question
connecting IIS to iSeries using ODBC
Replies
1
Views
67
Kozusnik
Kozusnik
Hayley78
  • Locked
  • Question
Power Edge R300 - Embedded Remote access Fail on Boot up
Replies
0
Views
66
Hayley78
Hayley78
goBoating
  • Locked
  • Question
backup to tape drive on remote host
Replies
4
Views
83
goBoating
goBoating
shogun1950
  • Locked
  • Question
(iSeries) Insert vars based on query in CLP
Replies
2
Views
70
shogun1950
shogun1950

Part and Inventory Search

Sponsor

Back
Top