SQLScholar
Programmer
Hey all,
Bit of a problem.
I have a chart (line chart) it plots the second line well higher then it should be. So i set up a second axis and it looks fine.
Unfortunately the another graph is doing the same but this is a filled line (dont know what its called, but imagine a line graph with the bit below it filled in).
It wont allow me to get to the section where i set a secondary axis. Any ideas why its doing this? or why its doing the problem in general?
Daniel
----------------------------------------
There are 2 types of computer, the prototype and the obsolete!!
----------------------------------------
No D, just plank - and its not my fault
Bit of a problem.
I have a chart (line chart) it plots the second line well higher then it should be. So i set up a second axis and it looks fine.
Unfortunately the another graph is doing the same but this is a filled line (dont know what its called, but imagine a line graph with the bit below it filled in).
It wont allow me to get to the section where i set a secondary axis. Any ideas why its doing this? or why its doing the problem in general?
Daniel
----------------------------------------
There are 2 types of computer, the prototype and the obsolete!!
----------------------------------------
No D, just plank - and its not my fault