Ethernet connection withe MD110 MX-ONE

[FERIEL123]

I have a problem with Ethernet connection to the NIU2 board.I tried to synchronize the PC server with the PBX with the MDsupport I get this error message "no invitation was received from noed PBX"
I use the TELNET protocol and I entered the name of the agent MDUSER and password HELP and IP but still the same error message I set up the IP address 192.168.1.10, mask 255.255.255.0 to the NIU2 . I have tested the cable between my computer and another one. It's O.K. I can't receive any response from the NIU2 board . I have restarted the board, I changed the position but with no effect.
Please give me an advice. Please help me!

 

[parnum]

Try if your card is in lim 1, (otherwise change the lim number)

RFPUI:UNIT=TWP3,LIM=1;
RFPUI:UNIT=NIP&FIP,LIM=1;

Best parnum

 

[FERIEL123]

Alright, I am not able to telnet (login with username and password) into the NIU2 board. However, I cannot use any of the MML commands. A compact flash card is present on the NIU2 board.

Like cv8devil mentioned,I do not have a license. But, I thought that the factory pre-load the unit with a license. If this is true, how can I access the license info (remember I can’t use the MML commands). If false, how come I can’t access the commands?

Thanks

 

[parnum]

Log on with the serial port on the NIU2, you won't be able to telnet without setting up the port 4 anyway, and you do need to load a valid license, it is not pre-loaded,

Best parnum

 

[FERIEL123]

NIU2 we have is ROF1375396 / 2 R3A you can only connect via telnet.
I think the problem is the IP address of the card. there is a way to find the IP address ,knowing that I can’t use the MML commands
I only have the mac address of the card,
I'm stuck, need your help
thank's.

 

[parnum]

Check the ARP on the local switch it's connected to

best parnum

 

[FERIEL123]

thank you "parnum" for your reply, I tried today with ARP but no result.
with software that is called "CCGetMAC" I sweated find the IP address of the card,when I try to connected to the PABX it asks me to login when I get the login do anything he does not give me access to enter the password I use SSSSS; it shows me an error "login rejected
what is happening.

 

[parnum]

you can't connect via telnet if port 4 is not programmed. NIU2 has serial port 1-3, use thst, if you cannot log in there then you need to rebuild the system, you must have the IP to get logon reject from SSSSS;
best parnum