Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ethernet Card installation
- Thread starter MrPants
- Start date
jrjuiliano
MIS
It's actually pretty easy.
Shut off the server, put in the network card. reboot, and it should find it OK on it's own.
from the command line:
CFGTCP
(note there's probably a shortcut for this but I couldn't come up with it!)
1 for add interface...
here's an example of ours
[red]
Internet address . . . . . . . . . : 10.10.3.2
Subnet mask . . . . . . . . . . . : 255.255.0.0
Line description . . . . . . . . . : ETHLINE
Line type . . . . . . . . . . . . : *ELAN
Associated local interface . . . . : *NONE
Interface status . . . . . . . . . : Active
Type of service . . . . . . . . . : *MAXRLB
Maximum transmission unit . . . . : *LIND
Automatic start . . . . . . . . . : *YES
[/red]
Note that you can also do this using Client Access Express, but since I started on the command line I'm sort of a purist at this point, and there's no turning back!
From there you can configure the services you want to start by going through the various options in "go network".
At the end all you need to do is STR TCP. You'll see all the services starting up at that point.
From there you should try to ping a host on the same subnet. If you can ping then you have it set!
Domain information can be done from the CFGTCP menu as well.
More information from the AS/400 information center for configuring with client access.
Hope this helps you! J.R. Juiliano
Information Systems Specialist
Tri-City Emergency Medical Group
Shut off the server, put in the network card. reboot, and it should find it OK on it's own.
from the command line:
CFGTCP
(note there's probably a shortcut for this but I couldn't come up with it!)
1 for add interface...
here's an example of ours
[red]
Internet address . . . . . . . . . : 10.10.3.2
Subnet mask . . . . . . . . . . . : 255.255.0.0
Line description . . . . . . . . . : ETHLINE
Line type . . . . . . . . . . . . : *ELAN
Associated local interface . . . . : *NONE
Interface status . . . . . . . . . : Active
Type of service . . . . . . . . . : *MAXRLB
Maximum transmission unit . . . . : *LIND
Automatic start . . . . . . . . . : *YES
[/red]
Note that you can also do this using Client Access Express, but since I started on the command line I'm sort of a purist at this point, and there's no turning back!
From there you can configure the services you want to start by going through the various options in "go network".
At the end all you need to do is STR TCP. You'll see all the services starting up at that point.
From there you should try to ping a host on the same subnet. If you can ping then you have it set!
Domain information can be done from the CFGTCP menu as well.
More information from the AS/400 information center for configuring with client access.
Hope this helps you! J.R. Juiliano
Information Systems Specialist
Tri-City Emergency Medical Group
- Status
Similar threads