Ether Channels and ESW 540 Sitches

[Primetime33]

We are trying to configure Ether Channels on our ESW 540 switches. We have configured the port(s) and made the physical connections but the Ether channel is only showing up at 1000M. It is my understanding that the port should be displaying at 2000M if configed with one pair of ports. Are there any other settings that need to be completed?



Thank you,
Brock

 

[VinceWhirlwind]

Give us a "show interface" for each of the 4 physical interfaces and the two port-channel interfaces.

A show int on the port channel will give you the speed/duplex setting that applies on all members of the channel-group, eg
"Full-duplex, 1000Mb/s"

A little higher in the output, it should give you the aggregate size of the link:
"MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,"

If there's any mismatch in speed/duplex of VLAN configuration between the members of the port-channel or between the physical interfaces and the port-channel interface, the port-channel will not come up.

 

[Primetime33]

Unless I am not aware of it, ESW 540 do not actually give you the option to do a show int.. Below is how each port is configured..

g23 1000M-ComboC Up 1000M Full 1

Port
Description
Port Type 1000M-ComboC
Admin Status
Current Port Status Up
Reactivate Suspended Port
Operational Status Active
Admin Speed
Current Port Speed 1000M
Admin Duplex
Current Duplex Mode Full
Auto Negotiation
Current Auto Negotiation Enable
Admin Advertisement Max Capability 10 Half 10 Full 100 Half 100 Full 1000 Full
Current Advertisement 10 Full 100 Full 1000 Full
Neighbor Advertisement 10 Full 100 Full 1000 Full
Admin Back Pressure
Current Back Pressure Disable
Admin Flow Control
Current Flow Control Disable
Admin MDI/MDIX
Current MDI/MDIX MDI
EtherChannel 1
PVE

Thank you,
Brock