ESM072 in LD 90

[detota3]

I cannot PRT, OUT or ADD a certain exchange in ld 90. It gives me errors either ESM072 or ESM072.

Normally if an exchange isnt loaded in the PBX when i dial, it gives a fast busy. This particular exchange (956) is wierd because it lets me dial the whole number, but i get **your call has not been completed as dialed.** But it is the correct number, and i can dial it from my cell phone.

What am I doing wrong?

Nick

 

[allenmac]

If you meant 'ESN072', then see below from the books:

ESN0072 NPA, NXX, etc., specified, already exists.
Action:
Severity: Info. Critical to Monitor: No. SNMP trap: No


If the first err should read 'ESN071', then here is the description of that message:

ESN0071 NPA, NXX, etc., specified, does not exist.
Action:
Severity: Info. Critical to Monitor: No. SNMP trap: No

Someone may have programmed your switch with a version of that NPA with a different length than the others. You can try guessing, or just print out the entire list, and search through the results to find the actual entry that is being used.

 

[detota3]

Yes sorry, ESN072

But when i try to OUT the exchange and start fresh, I get:

ESN073 "Conflict with another (NPA, NXX, ect.)"
Action: Enter new SPN number


Im not sure what that means

 

[RickyPone]

It may be in as an spn or an npa. Do like allen said and print them all.

 

[RickyPone]

If what you are looking for is 1234 just print 123 or 12. Do both spn and npa.