Error while booting

[surnj1]

Hi there,

i am getting following screen while booting on a SCO OpenServer 5.0.7, it stuck at "I USBSTART":

%ADV 0XDF00-0XDF3F 15 0 ADVANSYS UW/U2W/U3W SCSI V3.3B HA_NUM=0
WARNING:USB:CANNOT INSTALL INTR VECNO=12, TYPE=3, IPL=5
VECTOR 12 IS PRIVATE
%USB 0XEF40-0XEF52 12 - USB REV 1.1 INTEL CHIPSET
HUB ATTACHED:UHCI ROOT HUB PRODUCT 0X1,CSP9/0/0 REV 1.0, USB_id 1
%COMF 0XDF80-0XDF9F 10 - TYPE=PCI PORTS=4 V=2.03
%C3H 0XDC00-0XDC7F 15 - 3COM 3C90X/3C980, UNIT=0
%CD-ROM - - TYPE=IDE CTIR=PRI
CFG=MST DRV=SROM-7WD
%TAPE - - TYPE=S ha=0 iD=1 lun=0
bus=0 HT=ADV
%disk - - TYPE=S ha=0 id=1
LUN=0 bus=0 ht=adv
%Sdsk - - CYLS=2231 HDS=255 SELS=65
FTS=STDB
I USBSTART

 

[motoslide]

If you have a device attached to a USB port, can you simply remove it?

Did this system boot before? If so, what might have changed since the last successful boot?

 

[surnj1]

I have not changed any settings since last successful boot nor attached anything on USB port.

i am not using any USB port, Can i bypass loading that driver?

 

[motoslide]

I just found this on SCO's site:

boot: defbootstr disable=uhci

 

[motoslide]

Oops.. My bad:

This is the one they mention for 5.0.7:

boot: defbootstr disable=usb_uhci,usb_ohci,usb_ehci

 

[surnj1]

i tried that

boot: defbootstr disable=uhci

and it went futher on device drivers insted of hanging at USB and gave me error regarding my mouse, that I diconnected after previous successful boot. I was forgot about it as i am not using mouse as all my applications are keyboard based. attaching mouse back and rebooting the system resolved my problem.

Thanks for bearing with me.