Error when scheduling report....

[OldSkoolSkater]

Hi all

I have a report that fails every time regardless of which report server it runs on. upon checking the properties, it comes up with the following message
"PEStartPrintJob : Not enough memory for operation."
I have checked the crystal knowledge base but to no avail.
Any ideas?

 

[Nuffsaid]

Hey Snowdude...

I had a similar problem with one of my reports. What seemed to be happening is that so many temp files were being generated when I ran the report my C:\Temp directory grew so large that it ate up my whole hard drive and I got the same error message. To resolve this, in NT make your temp directory point somewhere where there is no space limitations. (remember NT only sees about 4 gig, if C:\Temp grows larger than that, you're hooped.) I changed my temp to D:\Temp (which is about a 100 gig hard drive). Havent seen that error message since......

Hope this helps...

Nuffsaid