Error: Module Not Found

[CharlieT302]

Hi Folks,

I have a major problem with a database. I can pull up forms, but the moment they attempt to run any code, the following error appears:

Module not found.

The database had been running for quite some time without incident. Has anyone experienced this before? Possible causes?

Thank you

 

[PHV]

Does the DB compiles properly ?
Have you tried the /decompile switch ?

Hope This Helps, PH.
FAQ219-2884
FAQ181-2886

 

[CharlieT302]

I have never formerly compiled a dbase. I thought that happened automatically. How would you go about ensuring it. Also, /decompile? Where would you run that.

By the way, some background info. This happens on any form the moment any code is accessed. Also, when I close the dbase, it informs me that a specific form (which I delete previously) doesn't exist or is misspelled.

I did notice that the referenced form appears in the system table: MSysObjects. There are no macros referencing it, nor have I used macros.