Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Error Message
- Thread starter Wavesg
- Start date
PRI0232
Protocol Error: PROGRESS INDICATOR not supported. Output data: DCH: x
DATA: y . Where: x = D-channel number and y = Message type.
Action: Contact your technical support group if the problem persists.
R18
Severity: Critical
This means the Cisco switch is sending a d-channel message the Meridian doesn't understand, ie an integration issue. Good luck in getting that resolved as my experience is that Cisco & Nortel will sit there pointing at each other.
Protocol Error: PROGRESS INDICATOR not supported. Output data: DCH: x
DATA: y . Where: x = D-channel number and y = Message type.
Action: Contact your technical support group if the problem persists.
R18
Severity: Critical
This means the Cisco switch is sending a d-channel message the Meridian doesn't understand, ie an integration issue. Good luck in getting that resolved as my experience is that Cisco & Nortel will sit there pointing at each other.
What you need to work on is the type of signalling you are recieving from Cisco. We use Call Manager with a Cisco and were able to get PRI working. We have since disco'd it since we don't work that project anymore.
I the RCAP of the DCH, try NI2 or ESS4/5 to get the dch to work. It will work....It's just a signalling issue.
john.anaya@broadwing.com
I the RCAP of the DCH, try NI2 or ESS4/5 to get the dch to work. It will work....It's just a signalling issue.
john.anaya@broadwing.com
- Status
Similar threads
- Locked
- Question
