I'm new to e*Gate Integrator. I have version 4.5.3.4707. I was trying to work through the tutorial and when I try to Compile and Save an ETD I get the following error message "Unable to set JVM classpath". I've tried looking for this message at the SeeBeyond Support webpage, with no luck. Can anyone help with this problem? Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Error Message, "unable to set JVM classpath"
- Thread starter Kenb917
- Start date
ken
when u try to compile & save ur ETD bear the following points in mind ---
check whether at the time of installation u have installed JDK 1.3/1.4 in the correct path...depends if u r going to use egate as client or server(for eg- like
"d:\egate\client\bin\*.jar""
and when u compile the ETD make sure that u convert the same in to a schema
try this and keep me posted!!!
cheers
when u try to compile & save ur ETD bear the following points in mind ---
check whether at the time of installation u have installed JDK 1.3/1.4 in the correct path...depends if u r going to use egate as client or server(for eg- like
"d:\egate\client\bin\*.jar""
and when u compile the ETD make sure that u convert the same in to a schema
try this and keep me posted!!!
cheers
- Status
Similar threads
