Error in Manager when viewing SCN configuration

[biv343]

I haven't played with SCN management outside of my lab sandbox. I installed several IP 500 V2 units for a customer and just configured Manager for SCN management. When I open the configurations using SCN management, I get an error stating "VCM support not present" against the units. The V2 units have either one or two combo cards, and the SCN works fine. I'm thinking this is just a bug in SCN management because a VCM isn't specifcally shown in the config when I look under the control unit card inventory. The error doesn't show up when opening the configuration outside of the SCN management view.

Anyone else run across this one?

 

[tlpeter]

I have seen it too and Avaya knows about it.
They did not manage to fix this fake error in the trials.
Just ignore it.


BAZINGA!

I'm not insane, my mother had me tested!

 

[biv343]

Thats what I was figuring. Appreciate it.

 

[Albus2]

Another one.
When the IPO's have spare phone or DS ports with empty base number, then manager complains about 'Extension number must be unique'. But if you click the error message, it disappears.