SameerKhan
Programmer
I started workin on Administering the Qs and have immediately run into problems, for Version 5.0 of MQ, I tried creating a QMgr,
-crtmqm MYQMGR
and this is how it responds,
AMQ6090: MQSeries was unable to display an error message for message id
hexadecimal 20008101, with inserts 2195, 0, , and .
Actually I get the same error message for any of the commands I am trying to run.
On Version 5.2, after I execute the command, it just sits there staring at me.
I checked, and I have already been added to the group mqm, Is there any other setup i need to do to be able to start off? Maybe I am missing some environment variables or something.
-crtmqm MYQMGR
and this is how it responds,
AMQ6090: MQSeries was unable to display an error message for message id
hexadecimal 20008101, with inserts 2195, 0, , and .
Actually I get the same error message for any of the commands I am trying to run.
On Version 5.2, after I execute the command, it just sits there staring at me.
I checked, and I have already been added to the group mqm, Is there any other setup i need to do to be able to start off? Maybe I am missing some environment variables or something.