Error codes ERR4076 and ERR4077

[odponce]

I started getting these error codes, and there is not much information available on the Nortel documentation. It started with XMI000 on the superloop, then the ERR4076 and ERR4077 started appearing.

The message indicates:

10 PPSI conflict found on IPE trunk during audit parameter download.

any help would be great.

 

[allenmac]

From the NTP:

ERR4076 tn 10 PPS1 conflict found on IPE trunk during audit parameter download.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes
ERR4077 tn 10 PPS2 conflict found on the IPE trunk during audit parameter download.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes

Is your system being flooded by these messages, or are you just getting them once in a while?

Both errors mention conflict found during audit parameter download, so I would double-check the system config of the DSPs, the virtual trunk route, and each virtual trunk tn to see if something is configured incorrectly.

 

[odponce]

I was getting XMI000 messages on the same shelf, I reseated the CONT card and all errors went away, including the ERR4077, and 4076.

Thanks for you input.