Can anyone point me in the right direction. I have a Phaser860 with this error. I can't figure out what to do. Most everything I read mentions postscript, however the tech support only tells me there is a bad internal part. No other avennues to try.Help!!!!!!!!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Error 15004.45:8804 2
- Thread starter gads31
- Start date
Smaug1Tech
Vendor
Howdy, your drum heater has a slow thermistor.check the sensor on the left of the drum inside the top door. Run a piece of paper through it to clean. Check the head to drum gap, and look to see if the heater even lights up.Try pushing heavy stock through the heaters flaps, they may be sticking.
-
2
- #3
If you are still having this error, let me know. The most common cause for this error code is a burnt out preheater light bulb, or sometimes the contacts for the bulb will burn away. Watch your printer on the right side as it first starts to warm up. You should see a white light flashing through the louvers after about one minute. I've replaced dozens of these bulbs, it's not an unusual occurrance.
- Status
Similar threads
- Locked
- Question
