Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

ERR4079

Status
Not open for further replies.

ASpark

Technical User
May 27, 2007
25
AU
hey guys,

i'm receiving this error ERR4079 when i try to enable an E&M for MOH, the card has been working fine for 2 years and today it stopped.

XMI002 0 0 8 XFEM

ERR4079 0 0 8 0
>!
>err err4079

ERR4079 tn
The hardware ID (type of unit (COT, DID, etc.) and signaling (LOP,GRD,
EAM, etc.) is not supported by the card (XUT, XEM, or any other IPE
trunk card). The software configuration no longer matches the hardware
configuration for the unit. Unit is disabled.
Check that correct card for desired trunks is in configured slot. Check
configuration of unit.
Severity: Minor

i have tried replacing the card with a spare, no luck, i even outed the programming and created it again on a new slot.

any clues ?

p.s the system has had a full power cycle.

Thanks


BCM/CS1K/IPOffice/Cisco CUCM & CUCME Engineer
 
What is part number of card and what Rls is PBX on?
 
XFEM , 000 0 08, NT5K83EA R01 NNTMEJ07A4F3 200712

the cs1k is R5.0

BCM/CS1K/IPOffice/Cisco CUCM & CUCME Engineer
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top