Ericsson MD110 E1 connection with RAD Vmux 2100

[EchoSpark]

I am trying to configure Ericsson MD110 with RAD Vmux 2100. I have Ericsson MD110 BC11 at the HQ connected to RAD Vmux 2100 using TLU 20. At the remote end I have an MD110 BC9 connected to another Vmux 2100 using TLU 76/3. The problem is that I can make calls from the HQ to the remote, but cannot make a call from the remote end to HQ. Please any help with what to do? Thanks

 

[singhbrindisi]

Hi,

Post Route parameters for both the lims...That will give a better picture..

BR,

 

[EchoSpark]

Route parameters for HQ(MD110 BC11)
ROCAP:ROU=34,SEL=011000000000001,TRM=4,SERV=3110000000,NODG=0,DIST=30,DISL=128,TRAF=00151515,SIG=411110000000,BCAP=101100
RODAP:ROU=34,TYPE=TL37,VARC=00000000,VARI=00000226,VARO=00012416,FILTER=NO

Route paramters for Remote Lim(MD110 BC9)
ROCAP:ROU=99,SEL=011000000000,TRM=5,SERV=3110000000,NODG=0,DIST=30,DISL=128,TRAF=00151515,SIG=411110000000,BCAP=001100
RODAP:ROU=99,TYPE=TL37,VARC=00000000,VARI=00000226,VARO=00012416,FILTER=NO

 

[lalrl]

not enough for analyzing. We need nadap:numtyp=ed; und roddp:dest=;

 

[EchoSpark]

Sorry folks for late reply.The problem has been resolved,the following changes were made on the Vmux 2100 at the remote location.
1. The clocking of the Vmux was set to internal because the clocking on the PBX was set to receive external clocking
2. The MFC signalling on the Vmux which was initially disabled was enabled.
In addition, voice was given priority over data.
Thanks for all your contributions.