ENTC command

[SherWat]

I have a CS1000E at 7.6
I would like to run the enhanced trace command (ENTC) for the next few hours to troubleshoot a phone that has intermittent issues.

In LD 80, entered ENTC 240 0 0 0 0500 to run for 5 hours
I then entered GOTR to start it.
when I enter FITR I see the trace there and all seems good
However, if I exit load 80, does it stop the trace command?

I found a procomm script from Firebirdscrambler under FAQ's and thought I would try that, but when I ran it, it just keeps looping
>LD 80
TRA000
.entc 240 0 0 0 0500


.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312

.entc 240 0 0 0 0500

TRA312




I have the capture file turned on, and my hope was that once I started the ENTC command, it would just run in the background for a few hours, generating data whenever her phone status changed.

Is this the intent for the ENTC command?
Thanks.

 

[StanleySteamer]

The ENTC is only active while you stay in LD 80.
Sorry

 

[Firebird Scrambler]

The procomm scripts works as intended. What you need to do is to enter in TRAC 0 extension number or TN.

The script was designed to be a snapshot that repeats every few seconds.

Example below

>ld 80
TRA000
.trac 0 2525

IDLE TN 240 0 0 0 0 MARP

.trac 240 0 0 0 0

TN 240 0 0 0 0
KEY 0 SCR MARP IDLE
KEY 1 RGA IDLE
KEY 2 CFW ACTIVATED

KEY 3 AO6 IDLE
KEY 4 TRN IDLE
KEY 5 MWK IDLE



Firebird Scrambler
Nortel and Avaya Meridian 1 / Succession and BCM / Norstar Programmer

Very advance high level knowledge on the Linux BCM phone system.

Website

http://somertel.com

 

[SherWat]

Understood. Thanks!

 

[Medo Shafik]

You can use ENTC command and then in gotr command like below
ENTC 240 0 0 0 0 0030 (for 30 min)
then
GOTR