Enabling OS4K for Video Conferencing

[Arshad Iqbal]

Hello Community,

Hope you all are doing great.

I am fairly new in Siemens PABX field and in process to learn. hope my dumbness will be tolerated here

I have OS4K fully configured for IP Telephony. I would like to enable Video Conferencing on it and integrate our existing Huawei SIP based end points located on different sites.

My question is, what applications/licenses or hardware I need to enable OS4K for video conferencing.

Best Regards

Arshad

 

[donb01]

I have 2 OS60 SIP phones set up for video so I can tell you that it works, and there were some weird things I had to do, but I don't completely remember what they were.

Here are some things I don't know if are relevant or not:

In the SBCSU record for those 2 phones (SIP) there is a parameter: PROT =SBDSS1

In the Voice3 tab of the COS I am using with those phones, UUS1M, UUS3 and TA are selected (among other common stuff)

In the Data tab of the COS for the phones, UUS1M, UUS3, BASIC and TA are selected (among other common stuff).

I know there was some minor tweaky stuff I had to do - I have the sheet for setting up the phones, but it also makes reference to the OS60 SIP Admin manual for a section on video. I can't remember anymore, but it was a pain in the butt to get it working and it took a long time before there there was finally a "Voila" moment and it worked. I don't think I did anything specific in the STMI config or WBM to make it work - I seem to recall it had to do with setting up the data mode correctly.


Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA

 

[sbcsu]

Also don't forget
CHA-ZAND:OPTLOAD;