Hello,
I just inherited a FC4500. But I cannot use the serial port to change the RAID sets. It outputs to the serial port with POST, the disclaimer and says it is turning control over to the serial port and then nothing else. It is seen by the system.
So, can I enable the serial port with a special character sequence or do I have to set/change jumpers on the SP or do I need software to configure this puppy?
Thanks.
I just inherited a FC4500. But I cannot use the serial port to change the RAID sets. It outputs to the serial port with POST, the disclaimer and says it is turning control over to the serial port and then nothing else. It is seen by the system.
So, can I enable the serial port with a special character sequence or do I have to set/change jumpers on the SP or do I need software to configure this puppy?
Thanks.