Enable menus on BPS2000

[telecom116]

I upgraded a BPS2000 to 2.5.1 software today using the command line interface (cli). After the upgrade, the menu system is no longer accessable; if I telnet or serial console into the switch all I get is the BPS2000> cli prompt. How can I restore the menu system?

 

[telecom116]

I finally found a service case on Nortel's web site dated 3/10 where someone had the same issue. They (like me) had upgraded to the SSH version of the BPS code. Installing the non-SSH version returned the menus to the system.

 

[fabianoboscatto]

All right, but i really aprecciate the new cli in the 2.5.1 version. It´s like Cisco CLI, very good, more simple than the menus.