ELU 76 AND ENRUTADOR CISCO PARA IP THE CISCO

[RJSIERRA55]

HELLO
I have a MD-110 Bc11, I must install a E1 with a Cisco 5300, as it must form ELU 76, and my configuration is:


<roCAP:ROU=13;ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
13 711000000000001 5 2110000011 0 30 128 00151515 111110000031 111111

END

<SUSIP:ROU=13,TRU=005-01;STATUS INFORMATION AT 09:55:42 13FEB04
ROU TRU TYPE TRAFFIC STATE/PTR LINE STATE/PTR ADD INFO
13 005-1 TL60 IDLE #0095 BLOCKED #0096
END

<RODAP:ROU=13;ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
13 SL60 H'00000110 H'15480000 H'04300000 NO

END

<RODdp:dest=2793;EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
2793 13 10050000000002500000000 0 1 0

 

[SYAR2003]

Try iso qsig channeling you to.
VARI from 15480000 to 55480000 .

syar

 

[megglesfield]

I don't have an example of the settings to a 5300 but below is an exmple of the route and ciso settings on a 3810. These same settings also work on the 2600, 3600 and 3700 series routers, so the should be the same for the 5300.

<ROCAP:ROU=158;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
158 711000000000001 5 3111000001 0 30 128 00151515 111110100031 111111

END

<RODAP:ROU=158;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
158 SL60 H'00000210 H'15420000 H'06300000 NO

END

<RODDPEST=33;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
33 158 160610000000025000600000 0 1 0
101 1 060620000000025000000110 0 6 0 920002248

END

<
controller E1 1
framing NO-CRC4
pri-group timeslots 1-10,16
loop-detect
!

interface Serial1:15
description ISDN LAYER 3
no ip address
ip mroute-cache
no logging event link-status
isdn switch-type primary-qsig
isdn overlap-receiving
isdn fast-rollover-delay 1
isdn incoming-voice voice
isdn global-disconnect
isdn send-alerting
isdn sending-complete
no fair-queue
no cdp enable
!
voice-port 1:15
cptone SE
timeouts initial 3
timeouts interdigit 2
description ISDN Ericsson
!