Electra Pro II adding new analog stations

[melbs1]

I now take care of an office that has a Pro II w/ expansion cabinet, I have installed a analog station card and hooked up the 8 analog phones.
I have no dial tone on the phones, the red light comes on on top of the analog card to indicate a port is in use, I assume I need to program the port.
The problem is I do not have any manuals for this system and do not know how to program beyond: FCN # 0 * and the password once I get into program mode I am stuck. I am not sure how to determine what port numbers I need to program, and not sure what programming to do.
Thanks in advance for any help or pointing me in the right direction while I search for manuals.

Melbs1

 

[Fixin]

In programming, be sure 7-1 has line key 8 lit for the slot your using. Then give the ports a valid ext number in 4-10.

 

[melbs1]

Thanks for the post Fixin, unfortunately I am too green with this system to know how to check if "7-1 has line key 8 lit for the slot your using".

I know my port numbers, but am unable to program them to be s/l extensions. Once I am in Program Mode I see the different modes by pressing the line keys.

I dont want to waste everyone's time on this, if anyone can point me in the direction where I can see/obtain manuals for this PRO II, that would be great.

Thanks-
Melbs1

 

[MrComputerTelephony]

Try techmanuals.com I think thats it...