Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

elan/tlan 1

Status
Not open for further replies.

dan miller

Technical User
Sep 2, 2021
1
US
I have a CS1000E that I'm adding 3 new loops with the MGC card needing programming. The existing loops have a data cable going from each port on the MGC from the elan and tlan ports to a 24 port Cisco switch. Does anyone know if the ports on the Cisco switch need to programmed any special way? Nobody in the group knows what the Cisco login password is, and the only way to retrieve it is to power down the Cisco switch and go through a bootup sequence. But I can't do that because the Nortel switch supports a highly classified program.
 
The cisco would normally have 2 VLANs set up for the ELAN & TLAN, this would need assigning to new ports if you are adding new gateways, unless you know that some of the ports are already set up.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top