EIGRP doing weird things

[volleyman]

All,

I have a fiber point-to-point connection between two sites. A cisco 6513 layer 3 switch on one side, a Cisco 3560 layer 3 switch on the other.

on the 6513, I run 'show ip eigrp neighbors" and I see:

H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) Cnt Num
3 10.x.x.18 Gi1/2 12 00:00:52 1 5000 7 0


the rest of my eigrp interfaces have a number under the seq num column, this one has 0...what does that mean?

when I run "sh ip eigrp int" it shows that it has 1 peer, which is as it should be, but it never gets a route from that interface.




Zane D.
Systems Admin

 

[volleyman]

even more strange...on one side, the 6513, I do a show ip eigrp interface. the interface in question shows 1 peer.

I run the same command on the 3560 and it shoes no peers. how does that happen? this only a PTP so there are only 2 connections.

Zane D.
Systems Admin

 

[unclerico]

can you post your eigrp configs??

I hate all Uppercase... I don't want my groups to seem angry at me all the time! =)
- ColdFlame (vbscript forum)