I have had the time of my life getting this working. I am working on an MXe with 9.0. We are using an edgemarc SIP firewall device to help prioritize the sip traffic. When it came time to port today, my cut sheet indicated that this carrier is sending digits in the E.164 format. This means it is formatted like so +19725555555 . I have tried Absorbing 8 digits, then 7, then 9...none of these work.
Though if you tell the edgemarc device to absorb 8 digits, the remaining 4 digits are sent across like a typical pri. After I set my trunk service group to absorb 0, those 4 digits come across normally.
If the edgemarc can absorb 8 digits and leave 4 remaining, I cannot see why the mitel cannot absorb and and leave 4 remaining. When I try this method broadband.com says that they see 404 not found, which makes me think too many or too little digits are coming across.
Anyone have any ideas why the mitel may be having trouble doing this?
Though if you tell the edgemarc device to absorb 8 digits, the remaining 4 digits are sent across like a typical pri. After I set my trunk service group to absorb 0, those 4 digits come across normally.
If the edgemarc can absorb 8 digits and leave 4 remaining, I cannot see why the mitel cannot absorb and and leave 4 remaining. When I try this method broadband.com says that they see 404 not found, which makes me think too many or too little digits are coming across.
Anyone have any ideas why the mitel may be having trouble doing this?