EDC auto Settle for Vantive and Vantive HCS 1

[AlohaRoss]

Setting up edc to auto settle is simple to do. But I dont have the correct procno for these two.
Vantive and Vantive HCS
I looked at a settlement file and it appears to be #20 but when I setup auto settle it still fails. Does anyone hvae the correct format

BEGIN
TYPE SETTLE
PROCESSOR [highlight #FCE94F]What is the correct processor to type here[/highlight]
PROCNO 20
PINDEX 1
END

EDC ver 12.3.30

AlohaRoss

http://www.needaholahelp.com

3rd Party support

 

[ClayTaco]

The processor name be under the settlement in the .stl file.
Should do the trick but some processors are weird. I haven't had any experience with Vantiv

 

[sheerdyn]

processor name should be the folder it creates in EDC

 

[AlohaRoss]

Yes that is true for both of you, but would you believe I did it with out any processor name, just the procno number and it works. I was ale to capture the req file for manual settle and am now using that same file with date and time stripped from it.

AlohaRoss

http://www.needaholahelp.com

3rd Party support

 

[ClayTaco]

Well today I learned. Neat little work around for random little processors.

 

[AlohaRoss]

BEGIN
TYPE SETTLE
PINDEX 1
PROCESSOR FIFTH THIRD HOST CAPTURE
END
fyi this is the req file. no procno just name. had it backwards.

AlohaRoss

http://www.needaholahelp.com

3rd Party support