Hi,
I'm after some guidance on the rucurring alarm above...
During busy periods (Proved using TM) i get congestion on the key code receiver, on Lim2 only triggering EC 283's
I have 3 x TMU's across 2 mags, so plenty of resources.
No lost signals.
TMU's restarted and FTMDI/FTTDI all ok.
No TMU's replaced as yet, as was looking as pinpointing this to a specific TMU.
Not sure how to do this from the add info...
1= record cong..changes
2= 598 - always same.
3= 40 - defined cong value.
Any help would be great!
thanks
Saf!
I'm after some guidance on the rucurring alarm above...
During busy periods (Proved using TM) i get congestion on the key code receiver, on Lim2 only triggering EC 283's
I have 3 x TMU's across 2 mags, so plenty of resources.
No lost signals.
TMU's restarted and FTMDI/FTTDI all ok.
No TMU's replaced as yet, as was looking as pinpointing this to a specific TMU.
Not sure how to do this from the add info...
1= record cong..changes
2= 598 - always same.
3= 40 - defined cong value.
Any help would be great!
thanks
Saf!
