Eagle Point 2003

[summajet]

I am using Eagle Point version 2003 and am using the feature to 'convert to lot' and naming the individual lots. When i use the mapcheck report and print out the lot information, the lot bearings derived by mapcheck is about 4 to 12 seconds off from what the actual line bearing is suppose to be. Any ideas on if i need to change a setting? I have looked under the mapcheck settings and do not see any option to change this. I would appreciate any help anyone can offer.
thanks,

 

[TCARPENTER]

Hi summajet,

Since nobody has chimed in on this one, I thought I'd take a stab at it.

You might try setting your precision as far as it will go, and change your units to decimal for both length and angles.

HTH
Todd