Greetings all,
At site "A" is a CS1000M cabinet on RLS 6 with 5 PRI's terminating in the system. At site "B" is where 95 percent of the sets reside, but they register to site "A" PBX. No SMG at site "B". Only the network connects site "A" PBX to site "B" phones. How do I program E911 at site "A" to show the address at site "B", even though the PRI's are installed at site"A". Do I need trunks that are physically tied to site "B" to install in site"A" PBX?
Thank You,
At site "A" is a CS1000M cabinet on RLS 6 with 5 PRI's terminating in the system. At site "B" is where 95 percent of the sets reside, but they register to site "A" PBX. No SMG at site "B". Only the network connects site "A" PBX to site "B" phones. How do I program E911 at site "A" to show the address at site "B", even though the PRI's are installed at site"A". Do I need trunks that are physically tied to site "B" to install in site"A" PBX?
Thank You,
