E2T programming?

[pea123]

thread1329-1056459
Hie to you all.How do you programme a static address for the E2T on a 3300 Mxe ICP, Im sure it does not have a port for the debug cable?If it does could you please take me through the procedure step by step.Thank you.

 

[Supernova99]

You need to use a secure telnet program (SSH telnet)
once installed open it and type the following from the prompt

open ip address 2007

The ip address is the mxe RTC address and 2007 is the port number of the E2T card

Once yoare in program a static IP address using the bootChange command

If you are familiar with the RTC then this is identical

Make sure that the host address is the RTC address

and remember to set flags to static 0x0 (0x40 is default dhcp setting)

I think thats it any questions please ask

Share what you know - Learn what you don't

 

[Supernova99]

Sorry forgot to add the link for the SSH telnet

http://www.mediafire.com/?ls77cvtgdd6dcot

Share what you know - Learn what you don't

 

[Supernova99]

I should also add that it is on page 275 of the tech handbook

Programming E2T via Debug Cable or Secure Telnet



Share what you know - Learn what you don't