Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

E1 R2 mfc/dtmf - help needed!

Status
Not open for further replies.

naosei2011

Programmer
May 16, 2011
1
BR
Hello everyone!

I'm not familiar to md110 (I'm a programmer, neewbie to telecom related things) and I've experienced some difficulties to configure E1/R2 properly....

here goes the current parameters
Is this R2 MFC? R2 DTMF?

I think the other side is 'talking' R2 DTMF...

<rocap:rou=30;
ROUTE CATEGORY DATA

ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP

30 0120000000000010 5 2100000017 0 30 128 03151515 311100000050 001100

END

<rodap:rou=30;
ROUTE DATA

ROU TYPE VARC VARI VARO FILTER

30 TL30 H'00000000 H'00002122 H'00000556 NO

END
 
This is MFC R2. If you want to try with DTMF, change VARI D8 to 1 and VARO D8 to 5.
 
If you do this, you should also ROCAC the SIG parameter with digit 11 equal to 0. It is 5 at present which is MFC.
 
now i start with ericsson md 110 and asterisk link to mfcr2
i speak spanish and my english is not good i can send my config
system

saludos

Jose luis luna
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top