Ok here is the scenario :-
Have been running exchange 5.5 on an NT Domain. We had one main e-mail address user@x.com but also had a secondary user@y.com. Some users were using both x.com and y.com to recieve e-mail. These e-mail domains were setup within the internet mail service and you used the routing tab to reroute x.com and y.com.
We now have migrated to Exchange 2003 on an active directory domain. The domain is called x.com. All mail that goes to x.com is routed to the mailboxes correctly but anything that goes to y.com bounces back to the sender. I have set connectors up for both x.com and y.com but this is not working.
Any advice on where I may be going wrong would be much appreciated.
Regards
Dan Broom
Have been running exchange 5.5 on an NT Domain. We had one main e-mail address user@x.com but also had a secondary user@y.com. Some users were using both x.com and y.com to recieve e-mail. These e-mail domains were setup within the internet mail service and you used the routing tab to reroute x.com and y.com.
We now have migrated to Exchange 2003 on an active directory domain. The domain is called x.com. All mail that goes to x.com is routed to the mailboxes correctly but anything that goes to y.com bounces back to the sender. I have set connectors up for both x.com and y.com but this is not working.
Any advice on where I may be going wrong would be much appreciated.
Regards
Dan Broom
