Good afternoon
I have an old siemans islx on an oil rig and onshore i have an old realtis phone switch. They are connected using 12 E&M trunks with a separate serial connector for signalling.
Acting as the carrier are two cisco routers at either end which provide e/m tunnels to the far end. There is no real cisco interaction.
I need to point the trunks to another location, however i only have cisco at my end ( yes i know, not a real phone switch)
I would like to place an avaya in the middle to provide a conversion between the ananlogue e&m and a qsig interface.
Can it be done using a small pbx and what do i need?
Any help would be appreciated.
cheers
I have an old siemans islx on an oil rig and onshore i have an old realtis phone switch. They are connected using 12 E&M trunks with a separate serial connector for signalling.
Acting as the carrier are two cisco routers at either end which provide e/m tunnels to the far end. There is no real cisco interaction.
I need to point the trunks to another location, however i only have cisco at my end ( yes i know, not a real phone switch)
I would like to place an avaya in the middle to provide a conversion between the ananlogue e&m and a qsig interface.
Can it be done using a small pbx and what do i need?
Any help would be appreciated.
cheers