Hi,
I have to connect two nortel Meridian 11C mini using E&M trunk.But I have not implemented earlier.Can any one help me by telling the Pin connectivity of the cable used between two meridians and the configuration of E&M trunk.
You can refer to NTP for installation on the E&M card setting and connection.1st pair is TX , 2nd pair is RX , 3rd pair is E and 4th pair is M.
Regards
stioac
three pair e&m or two? two things to try
pair 1 to pair 1
pair 2 to pair 3
pair 3 to pair 2 (type a or type b)
or
pr 1 to 2
pr 2 to 1
pr 3 to 4
pr 4 to 3
if its hook up right, a b+ on the e lead gives you dial tone from the local switch a b+ on the m. dial tone from the remote. Ear amd Mouth trunks are almost never used, whay did you go that route? i have a few left in for ran to interilia trunks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.