E&M trunks - I don't no what to do!!

[CHNascimento]

Hi all!! I've a big trouble. My costumer have 2 trunks E&M digital (DTMF) and I've the mission of configure that!!

I tried configure the trunk like TIE type and sinalization TONE!! The trunk was up (in-service), but i can't do or receiva calls!! I tried too like DIOD type and TONE. But the result is the same!!

Detail: The LIST TRACE TAC command not shows the seizure of trunk or another information!!

Anyone know how can I configure that??!

Thanks for any Help!!

CH ;-)

 

[PDHall]

Have you associated a signalling group?

 

[CHNascimento]

Yeas I Did! The ASA shows warning when you don't create any object!

tks

CH ;-)

 

[CHNascimento]

Today I will try configure the trunk with CONT signaling. When I test this I put the result!!

[]'s

CH ;-)

 

[CHNascimento]

The trunk Not Works! I don't know what to do!!

If anyone have a trunk this type, please send me the configuration!!

Thanks!!

CH ;-)

 

[1a22ip]

E&M Trunks don't have a signal group. The group should be Tie. See example Below:

Group Number: 3 Group Type: tie CDR Reports: y
Group Name: NJ LOCAL COR: 93 TN: 1 TAC: 103
Direction: outgoing Outgoing Display? y Trunk Signaling Type:
Dial Access? y Busy Threshold: 99
Queue Length: 0
Comm Type: voice
Trunk Flash? n

Trunk Type (in/out): wink/wink

Page 2 all defaults
Page 3 all defaults
Page 4 all defaults
Page 5 all defaults
Page 6
GROUP MEMBER ASSIGNMENTS Total Administered Members: 24

Port Code Sfx Name Mode Type Ans Delay
1: 02A0801 TN464 H e&m t1-stan 20
2: 02A0802 TN464 H e&m t1-stan 20
Try this Hope this helps
ED

1a2 to ip I seen it all

 

[CHNascimento]

Hello people, my trunk has works!! I got with this:

TRUNK GROUP

Group Number: 2 Group Type: diod CDR Reports: y
Group Name: TELECOM COR: 95 TN: 1 TAC: 502
Direction: two-way Outgoing Display? n Trunk Signaling Type: cont
Dial Access? y Busy Threshold: 99
Queue Length: 0 Country: 23
Comm Type: voice Auth Code? n Digit Absorption List:
Prefix-1? y Trunk Flash? n Toll Restricted? y

Trunk Type: immed-start







Group Type: diod Trunk Type: immed-start

TRUNK PARAMETERS

Outgoing Dial Type: tone Incoming Dial Type: tone
Trunk Termination: rc
Digit Treatment: Digits:
Expected Digits: Sig Bit Inversion: none
Analog Loss Group: 6 Digital Loss Group: 11
Trunk Gain: high Drop Treatment: silence

Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0 Receive Answer Supervision? y
Administer Timers? y


Other pages of trunks has the default configuration!!

Thanks for your help 1a22ip and PDHall!!
[]'s

CH ;-)

 

[jtabet]

Hello, I have the same scenario, but I am still working on the design.
What type of trunk card did you use from the Avaya side.
Can you please send me the hardware configuration of your PABX.