Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dynamic parameter populated from command file query issue

Status
Not open for further replies.

dellguy

Programmer
Aug 14, 2001
70
CA
Hello all.

CRYSTAL REPORTS 2016 Support Pack 7 Patch 5 v 14.2.7.3248

Just ran into something very strange. I have a dynamic parameter that is populated from the command file query for the report. The parameter is a multi-select list of employees. There are a couple employees that are in the output of the command file query but do not appear in the dynamic parameter drop down. Anyone see this before?

All comments and feedback appreciated.

LME
 
Yes, I believe there is a limit of 1000 values. If this is a multi-value cascading dynamic parameter, I think it has to take into account the potential values returned by any potential selection (if I’m remembering correctly—I have nothing here to test this on).

-LB
 
There is a limit of 1000, but there is a workaround by modifying a value in the registry.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top