This is strange.
I have Crystal Reports XI R2 SP3.
I have written a simple report with a crosstab which runs fine (from Crystal) using 'hard coded' static filters.
I then add a dynamic parameter (type DateTime).
When I run the report, I select the value(s) - as soon as I press OK, I see the report flash up, and then Crystal closes - no error - it just closes.
If I remove the dynamic parameter, it again runs fine.
The data source is a single MS SQL database.
I have also discovered that I can make Crystal close without error but changing the parameter to Static, and then adding all values (there are only 4).
I have Crystal Reports XI R2 SP3.
I have written a simple report with a crosstab which runs fine (from Crystal) using 'hard coded' static filters.
I then add a dynamic parameter (type DateTime).
When I run the report, I select the value(s) - as soon as I press OK, I see the report flash up, and then Crystal closes - no error - it just closes.
If I remove the dynamic parameter, it again runs fine.
The data source is a single MS SQL database.
I have also discovered that I can make Crystal close without error but changing the parameter to Static, and then adding all values (there are only 4).