Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Duplicated IPSI's or two control networks??

Status
Not open for further replies.

bpitt

Technical User
Jan 19, 2011
25
US
We're about to upgrade our old CM 3.0 to 5.2.1. I'm looking at our hardware and I'm trying to determine if we have Control Network A and Control Network B or is the IPSI's merely duplicated. Is there an absolute way to tell??
 
You'll need to check the IPSI IP addresses and server routing table. From the server shell, run the following:

pingall -i
/sbin/route

If the A and B IPSIs route over different interfaces then you have separate control networks (There is a lot more to it than this but this should get you started).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top