Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
duplicated group switch
- Thread starter 642234
- Start date
follow alex
6.15 Duplication of group switch
General
The active side of the group switch is defined with command GSDUI .
Active group switch side, is the side from where all GJULs are to receive speech, signalling and synchronization.
The group switch side is decided by the connection of the PCM line to the GJUL board, port 0 or port 1.
Prerequisites
All necessary hardware for duplication of the group switch side shall exist.
Execution
Measure/Question Observation/Comment
1 Connect the necessary hardware for duplication.
2 Key command GSDUI to initiate a duplicated group switch.
3 Key command GSDUI to change the active side in the group switch if that is desired.
4 Key commands GJLSP and GSMSP to check the result. See operational directions for GROUP JUNCTOR LINES .
6.15 Duplication of group switch
General
The active side of the group switch is defined with command GSDUI .
Active group switch side, is the side from where all GJULs are to receive speech, signalling and synchronization.
The group switch side is decided by the connection of the PCM line to the GJUL board, port 0 or port 1.
Prerequisites
All necessary hardware for duplication of the group switch side shall exist.
Execution
Measure/Question Observation/Comment
1 Connect the necessary hardware for duplication.
2 Key command GSDUI to initiate a duplicated group switch.
3 Key command GSDUI to change the active side in the group switch if that is desired.
4 Key commands GJLSP and GSMSP to check the result. See operational directions for GROUP JUNCTOR LINES .
- Thread starter
- #3
- Status
