dump problem (please )

[ozgur74]

SYSTEM DUMP INFORMATION
START PHASE 2 NOT EXECUTED AFTER INITIAL LOAD

do you know what it's mean ?
I have an md110 whith bc10TA (in fact i try to connect an ctt10 ).

 

[whosrdaddy]

you didn't do SFEXI after LAPUT

--------------------------------------
What You See Is What You Get

 

[ozgur74]

YESSSSSSSS
thanks a lot ....

 

[ozgur74]

Now it begening but after a few min , i had this message :
subfile system is full ...

sO i try again and now i have this message :
RESULT OF DUMP TO LOCAL BACKUP
SUCCESSFUL
RESULT OF DUMP TO EXTERNAL BACKUP
BUFFER TRANSFERT ERROR
FAILED FOR FILE PID

What can i do?

 

[whosrdaddy]

you must reformat your disk :

replace the 1-0-60 pos with your NIU/IPU pos

FIOFP:NODE=SYSN;
BLEQI:EQU=1-0-60-00;
FIMOE:SUBFS=TM-SUBFS;
FIMOE:SUBFS=SYSSUBFS11;
FIMOE:SUBFS=SYSSUBFS21;
FIMOE:SUBFS=SYSSUBFS31;
IOSIE:NODE=SYSN,IODEV=SYSDISK1;
IOSII:NODE=SYSN,IODEV=SYSDISK1,SIPOS=3,SUBFS=SYSSUBFS11&SYSSUBFS21&TM-SUBFS;
FICRI:SUBFS=SYSSUBFS11,size=64;
Y;
FICRI:SUBFS=SYSSUBFS21,SIZE=64;
Y;
FICRI:SUBFS=TM-SUBFS,SIZE=64;
Y;
FIMOI:SUBFS=SYSSUBFS11;
FIMOI:SUBFS=SYSSUBFS21;
FIMOI:SUBFS=TM-SUBFS,PATH=/SYSN/USR1/ACS/TM;
BLEQE:EQU=1-0-60-0,ALLFM=YES;


--------------------------------------
What You See Is What You Get

 

[ozgur74]

Yes thanks a lot , now it was succesful;
but i don't know if it's important or not , now he say :
LOAD OF STANDBY CONTROL SYSTEM INFORMATION
NO DUPLICATED LIM INITIATED

is it ?
What does it mean ?

 

[whosrdaddy]

don't worry about that.
it's fot duplicated processor systems. if you have only one LPU in your lim, this is a normal message

--------------------------------------
What You See Is What You Get

 

[ozgur74]

oki
thanks a lot for all this information

 

[wahacom]

Hi ozgur74.

I think any dump in future will given message( LOAD OF STANDBY CONTROL SYSTEM INFORMATION NO DUPLICATED LIM INITIATED ). for remove this the message use ( LAPUR ).

Regards.