Dual ringing thru 200 and 50

[geauxnads]

I have a BCM 200 3.7 and a BCM 50 at the second site and I want to be able to have the analog lines on the 200 to ring simulataneous 6 extensions on the 50. By setting up a Hunt Group on the 50 I can redirect the copper lines to the Hunt group DN and they ring...but not at both sites. Any thoughts on how to make both sites ring at the same time? Also if I want the 50 to be able to access the Valcom paging system of the 200 has anyone hooked up an IP2002 as an extension of the 50 at the 200 site and come off the speaker leads to the paging system ? This way you make a voice call to the DN of the IP2002 to page......

 

[Firebird Scrambler]

Can a line redirection facility via the target line be used on a spare extension to ring over to the hunt group?.

It's a tricky one as I don't think that you can add in numbers in a hunt group that don't belong as extensions on that system.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[gberger]

You can't have it ringing at both sites at the same time.
Hooking up the speaker of an I2002 to an amplifier in a remote site do work, have done it few times in the past.