Dual Pri Setup

[quazimotto]

Greetings!

I have been given a task by management to install a dual PRI card in a Cisco 1760. I have to connect one port to PSTN and the other use as a Tandem trunk to connect to a legacy Lucent system. I am a Cisco Newbie. Could someone send me some ideas on how to configure these ports as I haven't a clue? I have 12.4 software in a 1760 CME.

I appreciate all suggestions.

Thanks/Quaz

 

[jeter]

Is the PSTN PRI a full or fractional?

What is the other circuit for?


Go Army!
Tek-TIP Member 19,650

 

[quazimotto]

Jeter,

Both are full PRIs. One will connect to PSTN and the other I need to configure to link a Lucent Legend with the CME via PRI.

Quaz

 

[jeter]

Sorry for the delay!! Here is an example config, confirm with your provider the line setting an encapsulation...

Controll T1 0/0/0
frame ESF
Linecode B8ZS
Pri-Group timeslots 1-24

Interface Serial0/0/0:23
no ip address
encapsulation HDLC
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable


Voice-Port 0/0/0:23
Description *****PRI Voice Port*****


Setup your dial-peers for incoming and outgoing







Go Army!
Tek-TIP Member 19,650