DTI Module

[Johnthephoneguy]

I am installing a new BCM with 2 DTI modules. I don't have a T-1 in the office to program and test with, how much can I do with these without that? They are switched for Buss 4 and 5 but thats as far as i have gotten so far. i was going to wait until i was at the customers site but we need to get more done before then. Any ideas?

Thanks!

 

[danthephoneman]

Are they PRI or standard T-1's? Have you set the programmed bus type under resources to trunk module for bus 4 and 5?

 

[Johnthephoneguy]

yes they are programmed for the bus. It is a standard T-1.

 

[senk1s]

You can do all the programming and leave the testing onsite

You may program Target lines, stations, voice mails

 

[Crowtalks]

Check with your local ILEC and verify the T1 parameters that they send. Chances are, you will use all defaults or maybe only need to change one setting.