DTI Expansion Cabinet Network Cable

[Highlights]

Can I use a shot straight thru network ethernet cable to connect a DTI module to the BCM50 expansion port or is there a specific pin out ? There are two available EXP licenses available?

 

[Highlights]

The problem is that the MBM with the DTI card in it is not showing up on the Telephone Resources folder even though there are 2 available EXPs available.

 

[cook1082]

Yes you can use a straight thru patch cord. It is the last 2 ports on the Main unit for the exp. The last is #2 exp.

 

[hawks]

also make sure the cable is right around 15 to 16ft. If you make it to short or to long the system may not see it right.

 

[snowman50]

Ignore the last post .
That's for a bcm450 expansion chassis

 

[Highlights]

thanks it turned out that I could not get EM to DISABLE to port and I went thru the handset programming and was able to DISABLE, CHANGE and then ENABLE the port and it came on line. That is what I like about Nortel you can always use the handset for programming as a back up if EM is not available or offline.